Where is crankshaft position sensor located in a 1996 accord?
by what i understand its located between the crank pully and block.
1 person found this useful
i was told today that it is located somewhere around the timing belt. the timing belt cover must be removed. I'll have to futher research before i attemp to change it myself. …local mechanic told me he worked on one a month ago, changed plenty of parts, problem turned out to be the crank sensor. I've changed my ignition switch and the main relay, still having problems.
Crank Angle Sensor (location) i own a 98 Hyundai accent and the crankshaft position sensor is located just underneath the far right spark plug if your looking from the front …of the car,about 5"-8". hope this helps.
Where are the camshaft position sensor and crankshaft position sensors located in a 1996 olds aurora?
Answer . where are the camshaft position
It's inside the distributor housing.
It is located on the distributor under the cap and rotor Crank sensor should be on the front bottom of engine by the crank pulley
Four cylinder, center rear if the block. Six cylinder, top rear ofthe bell housing.
Answer . Bottom of the timing case on battery side..... look for the lowest wire connector in this area ...... best to get at from underneath.
Answer . This sensor provides a signal to an engine management computer or an ignition control module or igniter indicating the position of the crankshaft.
ON the rim of the bell housing at 11:00 if you are facing front, 1:00 if you are standing in the front looking back.
try this link http://www.autozone.com/autozone/repairinfo/componentlocations/componentLocationMain.jsp?categoryNValue=4294963514&categoryName=Crankshaft+Position+Sensor# . ba…sicly it is just above the oil filter. should have 3 wires running to it. If you are replacing it be sure to get the plug that comes with the new part. when I changed mine it didnt mach, I found out later there is a plug that comes with new parts that changes then pins from round to flat. had to splice the new plug in. . Jafo33990 good luck
\ni Would say not far from the The Face Bonnit ( Motor ) Engine ..
Inside the distributor. Replace distributor with OEM Genuine Honda Parts only.
The sensor is located on the right side of the the crankshaft attached by 2 bolts thru the timing cover it will be hard to see due to the pulley.
where is crankshaft position sensor and camshaft position sensor on a 2004 Jetta 2.0 gl
position sensor on a 96 accord ex located
Answer . between the intake manifolf and the firewall. Answer . \neveryone should have a manual for their vehicle, and the library should have a professional manual av…ailable...in the reference section, you'll have to make copies of the important sections...good luck :) The crankshaft position is always placed in and around the crankshaft pulley located at the front of the engine,often it is hidden behind the timing cover as these sensors are sensitive to road dust etc,be careful to observe torque specs on this sensor,the easiest way to locate is follow the only wire that runs behind the crankshaft pulley...r lyne