How do you replace the shocks for 2000 Dodge Durango?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

Rear shocks:
You will need 15 and 18 mm sockets or wrenches, but combination wrenches will work as well. First, place your vehicle on jack stands and also support the side you are doing with a jack. (If you remove the spare tire it will give you a lot more room to work.) Second, coat the bull pens (bolts that attach shocks to vehicle) with penetrating oil (like WD-40) and let set for a while. Then put you 15 mm socket on the bolt and the 18 mm wrench on the nut and controllably push the socket and pull the wrench to loosen bolt then remove all the way leaving the bolt on. On the top side you will want a socket extension. Put the wrench and socket on the same things as last time, but because it might be rusty you will have to work the 18 mm on to the nut. When you start removing the bolt only use the socket and let the wrench go where it wants because it should run in to another bolt that will hold it in place. Once loosened, remove again leaving the bolt on. Then take your wrench and hit the bolt so it comes out. After you get the bottom bolt out you should be able to pull the top on out. Once both bolts are out remove shocker. To put new ones back on just reverse the order. (Note: If you are replacing with gas shocks you will have to push them up a little bit. You might also have to use the wrench to get the bolt back in.) One more thing: When putting the nuts back on start them by hand then use the tools to get them on all the way. And tighten as tight as you can. I am not sure how to change the front shocks (if any) so you are on your own with that.
31 people found this useful

How do you replace the water pump on a 2000 Dodge Durango?

First drain the radiator. Then you'll need to remove the fan and shroud. Then remove the belts, water pump pulley, and hoses. Make note of how the belts run. When removing the water pump, note which length bolts came from which holes so you can get them back on right. Also note the position of any b (MORE)

Where is the signal flasher on a 2000 Dodge Durango?

\n. \n Answer \n. \n. \nIt should be in the fuse box in the 2000 models. On 2001 and newer, it is under the driver's side dash, just above the data link connector.\n. \nFor 2000 Durangos only: More correctly it is the square green relay looking unit located at the top and back side of the f (MORE)

Where is the blinker fuse on a 2000 Dodge Durango?

Answer . Should be in the fuse box on 2000 models\n. \n. \n. \n . IF you mean the four way flasher control button,it is on top the steering column between the dashboard and top half of the steering wheel.

How do you replace the center-high tail light on a 2000 Dodge Durango?

You need to raise the liftgate, then remove the liftgate upper trim panel. Remove the panel by carefully pulling straight out, it's only held in by spring clips. You'll now be able to access the bulb holders. Remove the bulb holders by rotating them 1/4 turn clockwise. The bulbs pull straight out fr (MORE)

How do you adjust the headlight on a 2000 Dodge Durango?

Open your hood, pull up to a garage door (or anything that will give you a flat continuous surface to see the beam) One the sides of the lamp cover there are little screws, if you look at the ends of them you will see they really do not hold anything in, these are the screws you need to adjust. Y (MORE)

Where are the plugs on a 2000 Dodge Durango?

Answer . \nThey are located down newr the bottom of the engine. One end of the plug is behind the engine close to the frame near the windshieldx. Then just follow the wire and you will findx them.

How do you replace the power steering pump on a 2000 Dodge Durango?

first you must remove the belt using a 15mm and breaker bar on the tensioner. drain all of the fluid out of the reservoir. i have used a shop vac and a tube long enough to reach the bottom of the reservoir to drain the fluid out. then you must loosen both of the lines attached to the pump. once you (MORE)

Blinkers not working on 2000 Dodge Durango?

Answer . \nbulbs ok?\n. \n. \nEveryone should have a manual for their vehicle, and the library should have a professional shop manual available in the reference section(make copies of the right sections) read up and fix it like a PRO! :) good luck

How and where do you recharge ac on a 2000 Dodge Durango?

you can recharge the air by removing the caps make sure you use a gauge type system you can over fill and put to much pressure on the compressor but make sure you do the one that has a (L) ON IT meaning the low pressure side not the high....you can get the recharge kits at advance auto parts its eas (MORE)

Where is the thermostat and how do you replace it on a 2000 Dodge Durango?

If you look down on the radiator, on the left side, there is a larrge hose coming out of the radiator toward the engine. Where the hose ends there is a housing with 2 bolts. The Thermostat is found under that. Remove the 2 bolts an replace the thermostat. Unles your arms are very long and thin, you (MORE)

How do you replace front wheel hub bearing assembly on 2000 dodge durango?

To my knowledge 1998-2004 are the same. Verify if you do or do not have front ABS The only part I will add: Make sure you use a high quality replacement part or you will be doing this again very soon. Answer from a certified Chrysler technician: http://en.allexperts.com/q/Dodge-Repair-809/1999- (MORE)

How do you replace the fuel pump on a dodge durango?

Replace 1999 Durango Fuel Pump - General The fuel pump and associated filter are in the gas tank. You must remove the gas tank from the vehicle as it is inserted into the gas tank and attached to the tank from the top. Some things to know (these steps may not be complete, but they will give you an (MORE)

How do you replace a starter in a Dodge Durango?

I just did my 1998 Durango starter today so this is applied information. 1. Set the parking brake and chock (block) both rear tires. Double check the parking brake. 2. Disconnect Both battery cables (most people do one but if the ground falls to a ground source the circuit can still be completed (MORE)

Why does 2000 Dodge Durango not start?

Turn over? Getting fuel? Getting spark? If you answered yes to all of these questions, your problem is a $15.00 relay you can buy at any auto parts store. It is located in the fuse box under the hood on the left side of the engine compartment. Plug in and go.

Where is the freon located in a 2000 Dodge Durango?

Answer . Does not contain any Freon (R12). Freon was banned and has not been installed in any vehicle since 1995.. there is freon in a 2000 durango,its in the air conditioner line,and it takes about 3 to 5 cans to fill it depending on how much is in it. you can buy everything you need to fill it (MORE)

Where is the starter located on a 2000 Dodge Durango?

Answer . located under the car where the transmission meets the engine Should be at the lower rear of the engine the driver-front tire has to be taken off and as you're sitting in the wheel-well, you'll see it on the right

Where is the crankshaft sensor on a 2000 Dodge Durango?

Most crankshaft sensors are located above the harmonic balancer next to the timing chain cover . Good Luck . Workin Man's Auto Repair ,Akron Ohio . Most crank sensors are above the harmonic balancer (front) or left of bell housing on the engine block (rear)

How do you replace headlamps on a 2001 Dodge Durango?

Open the hood and reach behind the headlight and twist out the lamp socket. Then take the bulb out from the socket. Replace with new bulb and twist socket back in. since it's a tight squeeze reaching behind, there is one small hex/torq bit screw on the fender side of the headlight. take out that s (MORE)

How do you replace the serpentine belt on a 2000 Dodge Durango?

This is a 15 minute job... use a 15MM socket and ratchet (set to loosen) to move the tension pulley (located directly below the oil dipstick) toward the battery side of the engine compartment. this will allow enough slack in the old belt to pull it off of the alternator. It will then come off everyt (MORE)

What transmission fluid for 2000 Dodge Durango?

I do believe that 2000 is one of those goofy years where some Dodge vehicles had different transmission fluid than others. I do know that you should use ATF+4 to be on the safe side. 2000 may be able to use ATF+3, however ATF+4 is backwards compatible with all Dodge transmissions. In other words (MORE)

How do you replace a power steering pump on a 2000 dodge durango?

Bleeding CAUTIONThe fluid level should be checked with engine off to prevent injury from moving components. WARNINGUse MOPAR® Power Steering Fluid (2001) or MOPAR® ATF+4 (2002 and later) is to be used in the power steering system. No other power steering or automatic transmission fluid is (MORE)

Where is the thermosatat on a 2000 Dodge Durango?

When you open the hood, look for the top radiator hose. Then follow that hose to the engine. You will see a metal piece that hose clamps to that is held onto the engine by two nuts. Remove those two nuts and pull up the metal piece. You will find the thermostat there. If you are replacing the Thermo (MORE)

Why is my 2000 Dodge Durango overheating?

1. change the thermostat. 2. radiator flush (possibly clogged) replace if bad. innerauto.com $150 3. fan clutch not turning possibly (replace) 2 & 3 destroyed my 4.7L engine in my 2002 Durango. You will get check gauges on dash.

Where is the maf sensor for a 2000 Dodge Durango?

On a 2000 Durango, the MAF sensor is known as an "ambient air temperature" sensor. Follow your air intake to the manifold. It's sticking out of the right side, under the manifold and looks like this:. http://www.autozone.com/autozone/catalog/parts/partsShelf.jsp?displayName=Sensor+-+Ambient+Air+Tem (MORE)

How do you replace the headlight on 2008 Dodge Durango?

If you are referring to the bulb, there is an access panel inside each of the front fender wells. Open the access panel using a flat tip screw driver. With panel open you can reach your arm into the the void behind the headlight twist the bulb one quarter of a turn the pull it out. Once out using yo (MORE)

How do you replace a thermostat for a 2000 Dodge Durango?

The thermostat is located (facing the front of vehicle) under the left end of the main upper radiator hose. Disconnect hose from flange by squeezing hose clamp until free.. Two bolts hold the flange down and they are NOT the same length. Keep track of which length comes out of which hole. Lift the (MORE)

Where is the fuse box 2000 Dodge Durango?

If you open the drivers door and look at the side of the dashboard, almost at the hinge, you should see a triangular shaped panel with a hole. stick your finger in the hole and pull toward the door. There's a fuse block there. There's a diagram of which fuses are there on the inside of the piece you (MORE)

How reliable is a 2000 Dodge Durango?

lots of factors, the Dakota and durango, 4.7 in my opinion is a great engine, the usually are good to about 150k than all starts to go, power steering, water pump, heater core, ect... suck on gas milage, 12miles per gallon, ave

How do you change shocks in a Dodge Durango?

To change the front shocks on a durango the best way is to place the vehicle on a jack .The jack needs to be under the lower control arm behind the tire and jacked up off the ground and tire removed from the vehicle.Loosen up the lower bolts and remove [this takes an impact wrench or a breaker bar a (MORE)

What is code P1682 for Dodge Durango 2000?

The code means "Charging system voltage too low". The PCM (computer) is not seeing the correct voltage from the alternator. Before you start ripping apart the engine to remove the alternator, check the serpentine belt tension. The tensioner pulley spring is prone to rusting and sticking, which cause (MORE)

How do you replace heatercore on a 2003 Dodge Durango?

The heater core is located in the vehicle behind the dashboard. It is a very time consuming job. The steering wheel/airbag, radio,dashboard has to be removed. Also need to drain some coolant. A backyard mechanic will spend the weekend(8+hrs) replacing it.