How do you replace the blower motor resistor cavalier 97?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

Tools required:
6mm socket/ratchet
7mm socket/ratchet
Socket U-joint with extension
Step 1: Loosen and remove the 7mm bolts (3) that hold the protective panel in place beneath the glove compartment. Remove this panel.
Step 2: Disconnect the blower motor resistor's wiring harness (1).
Step 3: Loosen and remove the 6mm bolts (2) that secure the resistor to the component.
You will need to use the U-joint and an extension to reach the bolt.
Step 4: Mount the resistor to the component by tightening the 6mm bolts (2).
Step 5: Connect the resistor's wiring harness (1).
Step 6: Tighten the 7mm bolts (3) that secure the protective panel to the underside of the glove compartment.
These Part Change / Installation Instructions Apply to
05 2005, 04 2004, 03 2003, 02 2002, 01 2001, 00 2000, 99 1999, 98 1998, 97 1997, 96 1996, 95 1995 Chevrolet Cavalier, Pontiac Sunfire Blower Motor Resistor Replacement Instructions
2 people found this useful

When you replace a blower motor do you have to replace the resistor module too?

Answer . \nSomething called a blower control module takes the place and is found in the hole where you would find a blower resistor, so there isn't a blower resistor in th

How do you replace the blower motor resistor?

I do not know what vehicle you are referring to but I just replaced one on a 1996 Nissan Sentra because the only speed that was working on the blower motor was 'high'. Underne

How do you replace a blower motor resistor in a 2003 Jeep Liberty?

Open your glove box and empty it out. There will be two supports on each side of the glove box, push these towards each other and the glovebox will kind of "fall out." It will

How do you replace a blower resistor on a 1998 Chevy cavalier?

This is a pretty simple fix. The GM part number for the Resistor is 52476725. Fits I believe 96-02 Chevrolet Cavaliers and Sunfire. Step 1: locate the blower motor under the d

How do you replace a blower motor resistor?

Safety Tip: Always wear safety glasses when working on your motor. Wear otherpersonal protective equipment (PPE) when necessary, for examplelatex gloves or closed toe shoes.

How do you replace the blower motor resistor pack on a Trailblazer?

1) Order the resistor pack from your local parts store or dealership. Shop around - prices vary quite a bit. Most parts stores will need to order this from their warehouse, so

How do you replace the blower motor resistor on a jeep 2000 Cherokee?

I just replaced mine and it took 30 minutes and the part was $35 (from Jeep dealer). Start by removing 3 philips screws that hold glove box in place (on bottom edge of glove b

How do you replace the blower motor resistor on a 2000 Camry?

Remove glove box. remove the side kick panel panel (a black knob) a hex bolt to be removed and 4 Phillips screws surrounding the glove box. Its all the way in the back under

How do you replace the blower motor resistor in a 2002 cavalier?

Cavalier Blower Resister Replacement . The resister is bolted in place beside the blower motor, which is located under the dash on the passenger side of the car. It is easi

Where is the blower motor resistor on a 2000 Chevy cavalier?

It is located under the dash on the passenger side of the car right behind the blower motor. I am getting ready to change the one in my wife's Cavalier for the second time. Th

How do you replace a blower motor resistor in 2006 Chevy Trailblazer?

"Front A/C blower would stop working intermittently the back blower works "OK". Tools needed: 5.5mm and 7mm (I use 7/32 and 9/32 nut driver or small sockets), wire cuter a