03 expedition Replaced front rotors and pads and still shakes when applying brakes?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

It must be the rear brakes at fault.
1 person found this useful

How do you replace the front brake pads on a 1999 Ford Expedition?

take the wheel off 2) You need to separate the brakes pads from the rotors. Remove the Calipers. You will need a TORX t-45 to remove the 2 bolts. 3) You need to decompress the calipers back using a C clamp. 4) the the old pads out, and replace with new. Do 1 at a time. One of them has a metal piece (MORE)

How do you replace front brake pads rotors on a2006 Ford F150?

Jack up truck and support safely on stands. Remove wheels and unbolt caliper on one side only. Use a c-clamp and push pistons back being careful not to overfill master cyl with brake fluid. Check rotor for wear and runout. If not worn or damaged clean caliper, instal grease on metal contact surfaces (MORE)

How do you replace the front disc brake pads on a 1999 Ford Expedition?

What you will need: The proper torx socket to remove the brake calipar(you can usually buy this at your favorite automotive supplier, ie. AutoZone, Pep Boys) and socket rench. A C-Clamp to compress the calipar. An old clean basting surenge that is disposable. An old clean bowl that is disposable. Do (MORE)

How do you replace the front brake rotors and the brake pads on a 1997 Toyota Tercel?

Chock the wheels. Loosen lug nuts slightly on wheel being changed. Jack up one side of car. Place on jack stand. Remove road wheel. On engine side of brake caliper are two 19mm bolts. Remove two bolts and slide caliper off rotor. Hang from spring with a coat hanger to prevent weight being put on the (MORE)

How do you replace the front brake rotors and the brake pads on a 2001 Mazda Protege?

The same procedure applies for both the front and rear rotors of the 2001 Mazda Protege. I did this a while back, so minute details might escape me at this time, but the procedure should be fairly simple, although there are some safety concerns to account for during the procedure, like the possibili (MORE)

You recently replaced your front pads and rotors and you can see that the back ones are fine but your brakes are still squeaking what should you do?

Answer . You need to apply "brake grease" to the back of the brake pads where they contact the caliper assembly and the caliper piston. DO NOT put the "brake grease" on the braking surface !! The auto parts store will have little packs of the stuff usually near the counter. The little packs run a (MORE)

How do you replace front brake pads and rotors on a 1998 Chevy Malibu?

remove wheel use i believe a T-55 torx bit to remove caliper if rotors are stuck carefully heat rotor center around hub assembly and remove rotor (easier said than done!!!) compress caliper piston with c- clamp replace brake pads and calipers then wheel. sometimes it is handy to remove the cap from (MORE)

What would cause a 1999 Olds Intrigue to shake when applying the brakes when the rotors and pads were replaced and tires were balanced twice?

Answer . \nSince it happens when your braking, I would still believe that the brakes are the source. A shaking when braking almost always points to a brake rotor or brake drum that is out of shape. If the steering wheel wobbles during the shaking, it is from the front. Also, drive the car for (MORE)

How do you get the rotors off to replace the front brake pads and rotors on a 2004 Silverado 4wd?

Answer . I just did this the other day om ny 2004 silverado. Once the tires are off, remove the brake calipers. There are two "star bolts" on the rear of the caliper (top and bottom). Remove these bolts using a T-55 socket bit. Then lift the caliper up to remove it. you might have to move i (MORE)

How much will it cost to replace the brake pads and rotors for a 2004 expedition XLT?

It won't cost you a dime. If you can follow instruction / or directions.. -----------------------------------------------------------. Replacing Disc Brake Pads . Caution *** . Older brake pads or shoes may contain asbestos, which has been determined to be cancer causing agent. Never clean the (MORE)

Do you need to replace brake pads when you replace rotors?

Answer . Strictly speaking, no. However, there will be a bedding period during which the braking abilities are less than maximum--occasionally dangerously less than maximum. Bedding is a reshaping of the brake pads to conform to the contours of the disk for maximum contact. If the rotor was repla (MORE)

What would cause the front driver side brake to vibrate whenever the brake is applied in a Chevy Astro van Rotor brake pads and bearings replaced twice. Both front calipers replaced once.?

Answer . have the brake disc turned. or maybe, too much play in front end. Raise front wheel and try to move it side to side (with out moving the other front wheel) side to side slop means worn out steering linkage or control arm. Might cause vibrations.. Answer . have the brake disc turned (MORE)

You just put on 20 wheels and tires on a 05 Chevy truck When you apply the brakes you get a bad shake you replaced the rotors and brakes and it still shakes What else could it be please help?

I believe it would be a problem with the ABS. Larger lighter 20's can be easier to lock up as they have higher pressures and smaller contact patches. What you are feeling is the ABS system trying to do its job. Oh and I am assuming the professional who put the 20's on your ride did get the right off (MORE)

How do you replace front rotors on a 99 expedition?

I just remove my Front Rotors (03/11/07) out of my 98 Ford Expedition XLT. I rented a 3 Jaw Puller from Auto Zone and a bottle of PB Blaster and a sledge hammer it only took about one hour or less to take both off... The way I removed the Front Rotors was ... 1. I put lots of PB Blaster in the (MORE)

How do you replace front brake pads and rotors on a 2000 Chevy Cavalier Z24?

It's simple actually you have to remove the tires and wheels if they are stock the lug nuts will be 19mm or 5/8. Now on the back side of the caliper there are a Allen key bolts at the top and bottom remove those now the caliper will be free. Now just pull the pads off pay attention to which goes on (MORE)

How do you replace front disc brake pads on a 2000 ford expedition?

Replacing Disc Brake Pads . Caution *** . Older brake pads or shoes may contain asbestos, which has been determined to be cancer causing agent. Never clean the brake surfaces with compressed air! Avoid inhaling any dust from any brake surface! When cleaning brake surfaces, use a commercially avai (MORE)

How do you get the rotors off to replace the front brake pads on a 2005 CR-V?

You don't need to take the rotors off to change the brake pads. If you need to replace the rotors or get them turned, here's how to get them off: 1) Make sure you remove the 2 small Philips head screws. 2) give the rotor a hard whack with a hammer, if this fails you will need 2 bolts, (6mm I believe (MORE)

How do you Replace front brake rotors and brake pads on a 1992 Cadillac Eldorado?

very simple take front wheels off then then with wheel turned (left /right) arroding to side, put a heay screwdriver between rotor and pad in slot of caliper slightly force piston in to keep pads loose, then there are two bolts hoding caliper on i think they are 15mm take bolts out get a wire hanger (MORE)

How do you replace rear park brake rotors and pads ford expedition?

Replacing Disc Brake Pads. Caution *** . Older brake pads or shoes may contain asbestos, which has been determined to be cancer causing agent. Never clean the brake surfaces with compressed air! Avoid inhaling any dust from any brake surface! When cleaning brake surfaces, use a commercially availab (MORE)

How do you replace front brake pads and rotors on a 2001 Volvo S80?

Hello, You can find following the procedure for replacing of the pads... FRONT BRAKE PADS... Remove the securing spring and locating pins Remove: -the securing spring carefully so that it does not deform -the protective caps from the two locating pins -the locating pins, use hex socket (MORE)

How much does it cost to replace front brake pads and resurface front rotors on a 1996 Ford Taurus 6 cylinder?

about 150 t0 175 dollars for brake pads and new rotors at advance auto Other pricing: Autozone: * Rotors range from $26 to $45 (don't buy the 'value' rotors - more likely to warp)* Rotors that are thick enough can be turned/machined - local shop does them for only $10-15 * Pads start at $19, (MORE)

Should you replace brake pads when replacing rotors?

Yes. No question about it. Back in the days of asbestos brake pads, you could get 80,000 miles or more out of the pads (well, I did on my Rover Metro, the first car I ever had with disc brakes - disc is correct English for what Americans call rotors), whilst the discs remained in perfectly good co (MORE)

How long does it take to replace front brake rotors and pads?

Always change rotors and pads in pairs, even though one side may seem OK. Note: Providing you come across no unexpected problems, have good tools, and have some experience with mechanical procedures. From jacking up car until road testing, about 2 - 3 hours. Including bleeding. Note: a frozen rotor, (MORE)

What should you do next to stop brakes from pulsating after you replaced the front rotors and pads?

may sound silly, but check that the discs are not in at and angle. also make sure there was copper grease on the rear of the pads. when you changed the pads and put the new ones in did you loosen the master cylinder cap. some calipers push air in the system when pads are replaced, due to the pistons (MORE)